Initial Settings; Auto Set Up - JVC DR-MV1B Instructions Manual

Filename [DR-MV1SEK_04Name.fm]
DR-MV1SEK_04Name.fm Page 19 Thursday, April 22, 2004 6:32 PM

Auto Set Up

Auto Channel Set/Auto Clock Set/Auto Guide Program
Number Set
After the 1 button on the unit or remote control is pressed for
the first time to turn on the unit, the Auto Set Up function sets the
tuner channels, clock and Guide Program numbers
automatically.
VCR/DVD
1
4
7
ENTER
SET UP
Before starting, make sure of the following:
The TV aerial cable should be connected to the unit.
The unit's mains power cord should be connected to a mains
outlet.
Turn on the TV and select the AV mode.
Slide the TV/CABLE/SAT/DVD switch to DVD.
1
Press 1 to turn on the unit. The Country Set display appears
on the TV screen. The AUTO SET/T-V LINK display appears on
the TV screen.
2
Press rt to select "AUTO
SET", then press ENTER. The
AUTO SET screen will appear,
and the unit automatically
performs Auto Channel Set.
When Auto Channel Set is
completed, "PLEASE WAIT" will
be displayed for about 90 seconds,
since channel data is exchanged
between the DVD deck and the VHS deck. No operation will be done
during this time.
ATTENTION:
When you have connected the unit
to a TV offering T-V Link via a
fully-wired 21-pin SCART cable
( pg. 18) and the TV is turned
on, the unit automatically performs
the Preset Download ( pg. 20)
even if you select "AUTO SET" for
Auto Set Up function.
ATTENTION:
Once you have performed Auto Set Up, even if the unit's memory
backup has expired, all the stored stations and their Guide
Program numbers remain in the unit's memory and the unit will
not perform Auto Set Up again. The unit only performs Auto
Clock Set when the unit is turned on.
If you have moved to a different area, perform each setting as
required.
Tuner setting ( pg. 83)
Clock setting ( pg. 86)
If a new station starts broadcasting in your area, perform tuner
setting. ( pg. 83)
Page 19
SAT
2 3
5 6
8 9
0
rtw e
NOTES:
In areas where no TV station transmits a PDC (Programme Delivery
Control) signal, the unit can perform neither Auto Clock Set nor Auto
Guide Program Number Set.
If there is a power cut, or if you press 1 or SET UP while Auto Set
Up is in progress, Auto Set Up will be interrupted; be sure to turn off
the unit power once and try again from step 1.
Auto Clock Set may not function properly depending on the reception
condition.
After "Auto Set Up" is completed, perform "Monitor Set (DVD
Deck Only)" on page 25.
Masterpage:Right0

INITIAL SETTINGS

19
EN
April 22, 2004 6:31 pm