Edit From A Camcorder - JVC 0503-AH-ID-JVE Instructions Manual

Edit From A
Camcorder
A
VIDEO input
Recorder
AUDIO input
Audio cable (not provided)
Video cable (not provided)
Camcorder
Player
B
S-VIDEO input
Recorder
AUDIO input
Audio cable (not provided)
S-Video cable (not provided)
Camcorder
Player
VIDEO OUT
AUDIO OUT
S-VIDEO OUT
AUDIO OUT
You can use a camcorder as the source player and your
recorder as the recording deck.
A
Make connections.
A If the camcorder has no S-VIDEO output connector ...
... connect the camcorder's AUDIO OUT and VIDEO
OUT connectors to the recorder's front panel AUDIO
and VIDEO input connectors.
B If the camcorder has an S-VIDEO output connector ...
... connect the camcorder's AUDIO OUT and
S-VIDEO OUT connectors to the recorder's front panel
AUDIO and S-VIDEO input connectors.
When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your recorder.
For the VHS deck:
When a Master Edit Control-equipped JVC camcorder is used,
the camcorder is capable of controlling the recorder. Refer to
the camcorder's instruction manual for operating procedure.
B
Select the recording deck.
Slide TV/CABLE/SAT to the right, then press HDD or S-
VHS.
C
Set the recorder's input mode.
Press AUX (number key "0") and/or VCR PR to select
"F-1".
Set "F-1 INPUT" to "VIDEO" for the VIDEO input connector,
or "S-VIDEO" for the S-VIDEO input connector, depending on
the connector being used (
D
Set the edit mode. (VHS deck only)
See "PICTURE CONTROL" on page 83.
E
Start the camcorder.
Engage the Play mode of the camcorder.
F
Start the recorder.
Engage the Record mode of the recorder.
NOTES:
All necessary cables can be obtained from your dealer.
When you select "EDIT" to dub tapes in step D, be sure to
select "AUTO" (or "NORM" when "B.E.S.T." is set to "OFF")
after you finish dubbing the tapes.
For HDD deck, the recording pause takes effect only when the
recorder is recording on the HDD deck with the channel set to
"L-1", "F-1", or "DUB". The recording pause is released in 5
minutes automatically. Picture and sound may be distorted at
the point where the recording pause is released.
It is not possible to record only the audio of the connected
equipment (without pictures) on the HDD deck.
67
EN
pg. 69).