2
1
EAS37P1027
DISASSEMBLING THE SECONDARY
SHEAVE
1. Remove:
• Clutch carrier nut "1"
TIP
While compressing the compression spring with
the clutch spring holder "2" and clutch spring
holder arm "3", remove the clutch carrier nut.
Clutch spring holder
90890-01337
Clutch spring holder arm
90890-01464
EAS37P1028
CHECKING THE CLUTCH HOUSING
1. Check:
• Clutch housing
Damage/wear → Replace.
2. Measure:
• Clutch housing inside diameter "a"
Out of specification → Replace the clutch
housing.
Clutch housing inside diameter
135.0 mm (5.31 in)
Limit
135.5 mm (5.33 in)
V-BELT AUTOMATIC TRANSMISSION (YP125R)
5-34
EAS37P1029
CHECKING THE CLUTCH SHOES
The following procedure applies to all of the
clutch shoes.
1. Check:
• Clutch shoe
Damage/wear → Replace the clutch shoes
and springs as a set.
Glazed areas → Sand with coarse sandpa-
per.
TIP
After sanding the glazed areas, clean the clutch
with a cloth.
2. Measure:
• Clutch shoe thickness "a"
Out of specification → Replace the clutch
shoes and springs as a set.
Clutch shoe thickness
2.0 mm (0.08 in)
Wear limit
1.0 mm (0.04 in)
EAS37P1030
CHECKING THE V-BELT
1. Check:
• V-belt "1"
Cracks/damage/wear → Replace.
Grease/oil → Clean the primary and second-
ary sheave.
2. Measure:
• V-belt width "2"
Out of specification → Replace.
a