Did / Tie Outgoing Assignment - Panasonic KX-TD1232 Program Manual

General Programming

[432] DID / TIE Outgoing Assignment

Description
Assigns a DID and TIE outgoing method, immediate or wink, to each DID / TIE format
according to your central office service.
Immediate: Outgoing DID and TIE numbers can be transmitted right after seizing the outside
line.
Wink: Outgoing DID and TIE numbers can be transmitted after receiving the wink signal from
the central office after seizing the outside line.
Selection
• DID / TIE format number:
1 to 8,
• Immediate / Wink
Default
All DID / TIE formats — Wink
Programming
1.
Enter 432.
Display: 432 SIGNAL OUT
2.
Press NEXT.
Display: Format NO?
3.
Enter a DID / TIE format number.
To enter DID / TIE format number 1, you can also press NEXT.
Display example: 1:Wink
4.
Keep pressing SELECT until the desired selection is displayed.
5.
Press STORE.
6.
To program another DID / TIE format, press NEXT or PREV, or SELECT and the desired
DID / TIE format number.
7.
Repeat steps 4 through 6.
8. Press END.
Conditions
• The time the system waits for the confirmation wink signal can be programmed in program
[435] DID / TIE Wink Time Out Assignment.
The system disconnects the outside line when the time-out time expires.
• To assign all DID / TIE formats to one selection, press the
In this case, the display shows the contents programmed for DID / TIE format number 1.
222
( =all DID / TIE formats)
key in step 3.
Programming Guide