Advertisement
INSTALLATION INSTRUCTION 83
Page 17/29
3.5 SOFTWARE PROGRAMMING
3.5.1 PREPARATION
To prepare the transceiver for programming set the switch in
the battery compartment to the programming position (A 3).
If the transceiver's batteries are replaced or an external power
supply is connected, the transceiver will switch on automati-
cally. On the alpha display a bar sign is visible underneath the
programming sign (Fig.1, indicator (F)) and the display indicates
one of the following transceiver versions:
Location of programming switch
Transceiver
Display
LBB 6063/02 or /04*
TB_ND
LBB 6063
TB
LBB 6064
TB+Dial
LBB 6065
TB+PS
LBB 6065
TB+Dial+PS (Talk-back, dial & PS)
* Only when an alphanumeric display is connected.
The second line of the display shows the software release ver-
sion. Indicated as follows:
SW-REL: **.**
* actual value depends on release version.
The receiver is now in the "Service mode" which provides the
following possibilities:
1
2
A
3
B
Functionality
(Talk-back no display)
(Talk-back)
(Talk-back and dial)
(Talk-back and PS)
DP 6000 DIGITAL PAGING SYSTEM
3.5.2 SERVICE AND INSTALLER FUNCTIONS
1 Viewing the addresses
2 Viewing the operation codes
3 Monitor mode
4 Installing mode
5 Test functions
6 Address programming
7 Operation code (opcode) programming
The selection of the above functions should be done as follows:
While the display shows the software version press the down
key. By repeatedly pressing this key the display will show:
"LANGUAGE"
"SHOW ADDRESS"
"SHOW OPCODE"
"MONITOR"
"INSTALLING"
"TESTING"
"POWER OFF ?"
The up/down keys can be used to scroll through the list of
functions.
1.
LANGUAGE
-
Press the up/down keys until the display shows:
"LANGUAGE".
-
Press the ENTER key.
-
Display shows:
Press the down key for the following languages:
GERMAN
FRENCH
USER DEFINED (NEDERLANDS)
Press the ENTER key to set required language.
2.
SHOW ADDRESS
-
Press the up/down keys until the display shows
"SHOW ADDRESS".
-
Press the ENTER key.
-
Display shows:
* Value of actual address.
Using the up/down keys, all the addresses can be
viewed on the display.
To move to another function, press the MENU key
followed by the up/down keys until the required
function is shown in the display.
February 1997.
(set required language)
(for viewing address function)
(for viewing the operation code
function)
(for the monitor function)
(for the installing function)
(for the test function)
(for the switching off function)
ENGLISH
ADDRESS 0
A3A2A1A0*
Advertisement
