Advertisement
DP 6000 DIGITAL PAGING SYSTEM
February 1997
3.
SHOW OPCODE
-
Press the up/down keys until the display shows
"SHOW OPCODE".
-
Press the ENTER key.
-
Display shows:
* Value of actual opcode.
Using the up/down keys, all the six operation codes can be
viewed on the display.
To move to another function, press the MENU key followed by
the up/down keys until the required function is shown in the
display.
4.
MONITOR
The following functions are available in the "Monitor" menu.
Using the up/down keys, all the monitor modes can be viewed
on the display.
Monitor call
Press ENTER to activate this function. While this function is
active the address and numeric information will be displayed
for each call in the system. When a call is received by the
transceiver, the display shows (when present in the call):
Call
<numeric info>
To move to another monitor function, press the up/down keys
until the required function is shown in the display.
Monitor message
Press ENTER to activate this function. While this function is
active the alphanumeric information will be displayed for each
alpha call in the system.
To move to another monitor function, press the up/down keys
until the required function is shown in the display.
Monitor speech / RSSI
Press ENTER to activate this function. While this function is
active, the transceiver will go in to the speech mode, and
speech can be monitored in the system, and the received HF
field strength is shown as an RSSI opcode value. This RSSI value
is only meant for system testing.
To move to another monitor function, press the up/down keys
until the required function is shown in the display.
Monitor Call counter
Press ENTER to activate this function. The transceiver will
count the calls addressed to address 0 transmitted by the sys-
tem, starting when this function is activated.
The display shows: CALL COUNTER
OPCODE 1:
PQRSTU*
<address><codinf>
<mode word>
<count>
INSTALLATION INSTRUCTION 83
To move to another monitor function, press the up/down keys
until the required function is shown in the display.
Monitor Location
Press ENTER to activate this function. While this function is
active the display will show the last received location address.
This function can be used to test the location receiver or to
site-test the range and placement of different location transmit-
ters.
The display shows:
To move to another monitor function, press the up key until
the required function is shown in the display. To move to
another function, press the MENU key followed by the up key
until the required function is shown in the display.
5.
INSTALLING
The following functions are available in the "Installer mode".
Using the up/down keys, all the installing modes can be viewed
on the display.
SET DEFAULTS
When set defaults is activated, the receiver address and opera-
tion codes are set into default values. All quick-dial numbers
are cleared. To activate this function proceed as follows:
When the display shows INSTALLING press the ENTER key.
The display shows:
SET DEFAULTS
To activate this function press the <Enter> key once again. The
display shows:
SET DEFAULTS
BUSY
After the default setting has been done, the display shows:
SET DEFAULTS
READY
Use the up/down keys to go to the next function available
within the menu.
Use the MENU key, followed by a up/down keys to exit the
installing functions.
The default settings are:
Address 0 - 6
CCCC
Opcode 1
:
Opcode 2
:
Opcode 3
:
Opcode 4
:
Opcode 5
:
Opcode 6
:
CAUTION: Returning the transceiver to its default set-
tings, will set the programmed RSSI value to its default
value. Please re-program this value according to the label
on the receiver module.
Page 18/29
LOCATION
<location address>
560047
0F056A
B71D84
4CE0F9
765631
080000
Advertisement
