Advanced Setup Menu Items; Changing The Speaker Impedance Setting (Speaker Imp.); Turning On/Off The Remote Control Sensor (Remote Sensor); Selecting The Remote Control Id (Remote Con Amp) - Yamaha AVENTAGE RX-A1040 Owner's Manual

ADVANCED SETUP menu items

• Default settings are underlined.
Item Function
SPEAKER IMP. Changes the speaker impedance setting.
REMOTE SENSOR Turns on/off of the remote control sensor on the main unit.
REMOTE CON AMP Selects the unit's remote control ID.
(Asia and General models only)
TUNER FRQ STEP
Changes the FM/AM tuning frequency setting.
TV FORMAT Switches the video signal type.
MONITOR CHECK Removes the limitation on HDMI video output.
Creates backup of the settings of the unit, or recovers the settings
RECOV./BACKUP
from the backup.
INITIALIZE Restores the default settings.
FIRM UPDATE Updates the firmware.
VERSION Checks the version of firmware currently installed on the unit.

Changing the speaker impedance setting (SPEAKER IMP.)

SP IMP. - SPEAKER IMP.
DOCK
TAG
HD
MUTE
STEREO TUNED PRE AMP PARTY
ZONE ZONE ZONE
ADAPTIVE
8 MIN
IN OUT 1 OUT 2 2 3 4
ENHANCER SLEEP
HD 3
Change the unit's speaker impedance settings depending on the impedance of the
speakers connected.
Settings
Select this option when you connect 6-ohm speakers to the unit. You
6  MIN
can also use 4-ohm speakers as the front speakers.
Select this option when you connect 8-ohm or higher speakers to the
8  MIN
unit.
VOLUME
DRC
PL L C R PR
SL SW1 SW SW2 SR
PL SBL SB SBR PR
Turning on/off the remote control sensor
(REMOTE SENSOR)
SP IMP. - REMOTE SENSOR
DOCK
TAG
HD
STEREO TUNED PRE AMP PARTY
ZONE ZONE ZONE
Page
2 3 4
IN OUT 1 OUT 2
ENHANCER SLEEP
HD 3
129
Turn on/off the remote control sensor on the main unit. While the remote control sensor
129
is turned off, you cannot control the unit from the remote control.
129
Settings
130 ON
OFF
130
130

Selecting the remote control ID (REMOTE CON AMP)

131
131
SP IMP. - REMOTE CON AMP
DOCK
TAG
HD
STEREO TUNED PRE AMP PARTY
ZONE ZONE ZONE
131
2 3 4
IN OUT 1 OUT 2
ENHANCER SLEEP
HD 3
131
Change the unit's remote control ID so that it matches the remote control's ID (default:
ID1). When using multiple Yamaha AV receivers, you can set each remote control with a
unique remote control ID for its corresponding receiver.
Settings
ID1, ID2
■
Changing the remote control ID of the remote control
1
To select ID1, hold down the cursor key (e) and SCENE (BD/DVD) together for
3 seconds.
To select ID2, hold down the cursor key (e) and SCENE (TV) together for 3
seconds.
CONFIGURATIONS ➤ Configuring the system settings (ADVANCED SETUP menu)
MUTE VOLUME
ADAPTIVE DRC
ON
PL L C R PR
SL SW1 SW SW2 SR
PL SBL SB SBR PR
Turns on the remote control sensor.
Turns off the remote control sensor.
MUTE VOLUME
ADAPTIVE DRC
ID1
PL L C R PR
SL SW1 SW SW2 SR
PL SBL SB SBR PR
129
En