Pppoe (Dsl) - D-Link AC750 User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through a router.
My Internet Select PPPoE (Username/Password) from the drop-down
Connection: menu.
Address Mode: Here the user can specify whether this Internet connection
requires the use of a Dynamic or Static IP address. PPPoE
usually requires a Dynamic IP configuration.
IP Address: Enter the PPPoE IP address used here. This option is only
available if Static IP is selected.
Username: Enter the PPPoE account user name used here. This
information is given by the ISP.
Password: Enter the PPPoE account password used here. This
information is given by the ISP.
Verify Password: Re-enter the PPPoE account password used here.
Service Name: This optional field enables the user to enter a service name
to identify this Internet connection here.
Reconnect Mode: Use the radio buttons to specify the reconnect mode.
The user can specify a custom schedule or specify the On
Demand, or Manual option. To specify a custom schedule,
use the drop-down menu to select one of the schedules
that has been defined in the Schedules page.
To create a new schedule, click the New.Schedule.button to open the Schedules page. Schedules will be discussed later.
D-Link DIR-816L User Manual
Internet Setup

PPPoE (DSL)

68