Express Timer Programing - JVC HM-DH30000U Instructions Manual

38
EN
Express Timer
Programing
Turn on the VCR and the TV, and select the AV
mode on the TV.
VCR TV CABLE/DBS
DAILY (M-F)
DBS
3 – 7
2 9
1
POWER
1 2 3
4 5 6
8 9
7
WEEKLY
0
0
8
9
TIMER RECORDING (cont.)
You can directly program the VCR's timer to record up to
24 broadcasts, as far as a year in advance. Remember,
the clock must be set before you can program the timer
( pg. 10).
1
Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape, then load it
into the VCR.
The VCR turns on, and the counter is reset,
automatically.
2
Access VCR PLUS+ screen
Press PROG..
3
Access Program screen
Press START +/– once.
4
Set program start time
Press START +/–
repeatedly to enter the
time you want
recording to start.
Press and hold START
+/– to increase the
time in 30-minute
intervals.
5
Set program stop time
Press STOP +/– repeatedly to enter the time you
want recording to stop.
Press and hold STOP +/– to increase the time in
30-minute intervals.
6
Set program date
Press DATE +/–. (The current date is displayed on
the screen. The date you enter appears in its
place.)
7
Set channel number
Press CH +/–.
If you are using a DBS receiver, see
"ATTENTION FOR DBS RECEIVER USERS" on
next page.
Holding down CH +/– rapidly changes the
channel numbers.
PROGRAM
START STOP DATE
– –:– –AM – –:– –AM – –/– –/– –
CH SUN
– – – STD (SP)
PRESS (+/–, SP/EP, 8=DAILY
9=WEEKLY) THEN (OK)
PRESS (PROG.) TO END
PROGRAM
START STOP DATE
8:00AM – –:– –AM – –/– –/– –
CH SUN
– – – STD (SP)
PRESS (+/–, SP/EP, 8=DAILY
9=WEEKLY) THEN (OK)
PRESS (PROG.) TO END