Nokia 9000i Service Manual page 167

After Sales
Technical Documentation
Minimum mode switch
+ –
to power
Supply
DLR–1
Loading the Software
The program is delivered on a diskette and can also be installed on the
hard disk, which is recommendable to obtain maximum data access rate.
Do not lose your original diskette. It will be needed when upgrading the
program.
To start the program on diskette, proceed as follows:
1. Insert Service software diskette into drive A: of your PC
2. Log into drive A:
3. To run software
To start the program on hard disk (if installed), proceed as follows:
1. Log into drive C:
2. To run software
Amendment 1 04/97
PAS–1
Dummy Battery
DAU–2/2T
Figure 2. Servicing setup
type A: press <Enter>
type rae_1 press <Enter>
type C: and press <Enter>
type rae_1 and press <Enter>
Service Software
COM1 COM2 LPT–1
PKD–1
RAE/RAK–1N
PC
Page 7– 9