Setting Up The Dtv Automatically - Sony TRINITRON KD-34XBR2 Service Manual

Setting Up the DTV Automatically

z
The initial setup screens appear
only after turning on the DTV the
first time, or after selecting Factory
Reset in the Setup menu (pag e60).
If you need to set the clock at a
later time, press the TIMER button
on the remote control (see
page 45).
You can also run Auto Program at
any time from the Channel Setup
menu (see page 54).
z
You can run the
demonstration again by
selecting Demo from the Setup
menu (see pages 60 to 62).
The first time you turn on the DTV, a series of screens guide you
through the initial setup of the DTV. During this setup, you are
prompted to set the clock and start Auto Program, which searches for
and stores a list of analog and digital channels you are receiving for
VHF/UHF and CABLE inputs.
✍
Be sure to complete all connections before turning on the DTV the first time.
1
Press to turn on the DTV and display the Welcome screen.
POWER
to come
2
Press to continue Setup. The set clock screen appears.
3
Move the joystick V and v to set the current day and time (hour,
minute, and AM/PM). Press
each setting and move to the next setting. Move the joystick
go back to the previous setting.
4
After you've set the clock, move the joystick
and press to continue Setup. The Auto Program screen
appears.
5
To start Auto Program, press
automatically creates a channel list of analog and digital
channels. (This may take a few minutes.)
6
When the channel list is complete, a Congratulations screen
appears.
To see a short demonstration of the features of the DTV, press
to select A self-running introduction to the features of the
Demo.
DTV begins. To exit the demo at any time, press any button on
the remote control (or front panel).
To skip the demo and exit Setup, move the joystick
and press
Done
Connecting and Setting Up the DTV
or move the joystick
to select
.
to confirm
b
B
to highlight
Next
b
. The DTV
Auto Program
to highlight
b
31
to