Important Service Guide; Mode Switch (Program Switch) Assembly Point; How To Eject The Cassette Tape - Sony SLV-SE220 Service Manual

QQ
3 7 63 1515 0

MODE SWITCH (PROGRAM SWITCH) ASSEMBLY POINT

1) When installing the ass'y deck on the Main PCB, be sure to align the assembly point of mode switch.

HOW TO EJECT THE CASSETTE TAPE

TE
L 13942296513
(If the unit does not operate on condition that tape is inserted into housing ass'y)
1) Turn the Gear Worm Πclockwise in the direction of arrow with screw driver. (See Fig. 2)
(Other method ; Remove the screw of Motor Load Ass'y, Separate the Motor Load Ass'y)
2) When Slider S, T are approached in the position of unloading, rotate holder Clutch counterclockwise after inserting screw driver in the
hole of frame's bottom in order to wind the unwiunded tape. (Refer to Fig. 3)
(If you rotate Gear Worm Πcontinuously when tape is in state of unwinding, you may cause a tape contamination by grease and tape
damage. Be sure to wind the unwiunded tape in the state of set horizontally.)
3) Rotate Gear Worm Πclockwise using screw driver again up to the state of eject mode and then pick out the tape. (Refer to Fig. 2)
ΠGEAR WORM
www
.
Fig. 2
http://www.xiaoyu163.com

IMPORTANT SERVICE GUIDE

x ao u163
y
i
— 4 —
http://www.xiaoyu163.com
2 9
8
Fig. 1
Q Q
3 6 7 1 3 1 5
FRAME
co
.
Fig. 3
9 4 2 8
ASSEMBLY POINT
(ALIGN TWO ARROWS)
0 5 8 2 9 9 4 2 8
m
9 9
9 9