Operation And Settings; Projecting Image - JVC DLA-SH4KNL Instructions Manual

Operation and Settings

Projecting Image

If setting for this projector is not completed, refer to the
"Setting Menu" (A Page 30) upon turning on the power
and configure the settings accordingly.
Once the basic settings are configured, this projector can
be used by simply performing the following operation
procedures.
PREPARATION:
● Remove the lens cap.
● Connect this projector to the computer. (A Page 19, 21)
● Connect the LAN cable. (A Page 22)
1
Set this projector to the standby mode, and
display the main menu
● Refer to "Turn on the main power" (A Page 23),
and steps 4 to 6 of "Assigning an IP Address"
(A Page 26).
● The [STANDBY/ON] indicator lights up in red.
2
Click the ON button under the Power item
of the main menu to project the image
● The power of this projector turns on, and formatting
is done taking a few minutes. A gray image will be
displayed during formatting.
The projected image appears once formatting
ends.
● The [STANDBY/ON] indicator lights up in green.
Power
Main
Image
ON OFF
Setting
Signal Status
Convergence
DVI Rate(Hz) Pixel H
Lens
1 60.00 2048
Option
2
Network
3 60.00 2048
Mail
4
Projector Usage
Lamp Time
NOTE:
● You can also turn on the power by pressing the
[OPERATE I/B] button on the projector unit for more
than one second.
● The image may flicker for a few seconds immediately
after projection starts. This is not a malfunction.
● After the lamp lights up, it takes about 1 minute or
longer for the brightness of the video image on the
screen to stabilize.
host PJ-1
user: root
Logout
Latest Error
STANDBY 00
Temperature
Pixel V Link
Temp. 1
2400 Dual
36.0 deg.C
Temp. 2
2400 Dual
25.5 deg.C
1035h24m
Reset
3
Adjust the zoom ratio (screen size) (when
zoom lens is in use)
You can adjust the focus using the Zoom item of the
Lens menu.
Zoom Focus
Main
w +
Image
Setting
Convergence
Lens
Option _
Network
T
Mail
To enlarge the screen size:
Press the W (Wide) end of Zoom
To reduce the screen size:
Press the T (Tele) end of "Zoom"
NOTE:
● The screen size changes each time you click on the
inner buttons ( / ). (Fine control)
The outer buttons ( / ) change the screen size when
they are depressed. (Coarse control)
4
Adjust the position of the projection screen
You can adjust the focus using the Shift item of the
Lens menu.
To shift the image upward:
Press the U end of Shift
To shift the image downward:
Press the D end of Shift
To shift the image rightward:
Press the R end of Shift
To shift the image leftward:
Press the L end of Shift
NOTE:
● When a zoom lens is used, the adjustment range for
lens shift is between 0% to
direction, and between 0% to
direction (during single-screen display).
When a short focal length lens is used, the adjustment
range for lens shift is between 0% to
vertical direction, and between 0% to
horizontal direction (during single-screen display).
(A Page 14)
● The position changes each time you click on the inner
buttons ( / ). (Fine control)
The image shifts when the outer buttons ( / ) are
depressed. (Coarse control)
● The lens shift feature does not function if the lens
mechanism is secured. (A Page 14 Lens Fixation
Mechanism )
host PJ-1
user: root
Logout
Shift
U
L R
D
50% in the vertical
25% in the horizontal
15% in the
5% in the