Table of Contents
Advertisement
Applications
Flash Memory Utility
(continued)
Reading Preset Data
This section describes procedures for reading the preset data from
the flash memory.
1
Insert the flash memory device into the
[SERIAL] terminal on the front (rear) panel
2
Select [Load Setting Data]
● If data is stored on the flash memory device, a list of data
stored in the device will appear in the preset data list.
● The [Flash memory cannot be detected] message may
appear in some cases. In this case, wait for about 30
seconds and select [Load Setting Data] again.
● Preset data that is stored on this unit is indicated by My
Machine at the beginning. Data stored on other NVR
units is displayed as Other Machine . This is followed by
a pair of parentheses, which contains the MAC address of
the NVR where data was saved. This is followed by the
saved date/time in the yyyy-mm-dd-sec-Setting format.
● If multiple data are displayed, highlight the data in the list
that you want to read.
[Setting Data List] Screen
3
Select the setting to load, followed by pressing
[Load]
● The highlighted data will be read.
4
The [Load Setting Data?] confirmation message
appears. Press [OK].
● The preset data will be read.
● When reading is complete, a message informing you that
data has been read appears. Click the [OK] button.
5
Press [Close] to return to the [Flash Memory
Utility] screen
Removing the Flash Memory Device
1
Select [Remove Flash Memory]
● The [Remove Flash Memory?] confirmation dialog
appears. Press [OK].
● The [Flash Memory was removed] message appears.
Press [OK].
2
Remove the flash memory device from the
[SERIAL] on the front (rear) panel
Memo :
● Items specified in the [Image Quality...] settings of [Main
Menu]-[Camera Record Setting] (A Page 58), [OS Setting]
(A Page 72), and [Password] section of [Unit Setting]
(A Page 69) will not be saved.
● To read the preset data after you have selected [Remove
Flash Memory], remove the flash memory device from the
serial terminal and insert it again. When the flash memory is
inserted, it will be automatically detected.
Note :
● If you are reading preset data saved using a different language
setting, change [Language Setting] of the [Main Menu] to the
language used when the data is saved.
● If a Master/Slave setup is created using Milestone System's
Enterprise 6.0 on an NVR, settings on that unit cannot be loaded
on another NVR.
● Data saved using VR-N900U cannot be used on VR-N1600U/E.
and vice versa.
Advertisement
Table of Contents
