Using The Cascade Connection Via Lan (Up To 10 Points) - Sony PCS-1 Operating Instructions Manual

Using the Cascade Connection via LAN (Up to 10 Points)

Installing the optional PCS-323M1 H.323MCU software in two
Communication Terminals enables cascade connection, allowing you to
conduct a multipoint videoconference among up to ten points.
PCS-323M1
H.323 MCU
software
TERMINAL
AUDIO OUT AUX1– VIDEO IN –AUX2 AUDIO IN
(MIXED)
VIDEO OUT
AUX MAIN– MONITOR– SUB
RGB OUT
to 100BASE-TX/
10BASE-T
Notes
• Installing the PCS-323M1 H.323 MCU software into three or more Communication
Terminals does not allow cascade connection. Note that the third or later terminals
should set "Multipoint Mode" to "Auto" in the Multipoint Setup menu or in the Setup
menu.
• For cascade connection, the "Split" and "Split (Fixed)" modes are not available. Only
the "Voice Activate" mode is available.
172
Connection Examples for a Multipoint Videoconference
to LAN
VISCA OUT
CAMERA UNIT MIC
(PLUG IN POWER) ISDN UNIT WHITE
1 2
BOARD
100BASE-TX DC 19.5V
10BASE-T
DSB
IR OUT
1 2
UTP cable (category 5,
straight) (not supplied)
PCS-323M1 H.323
MCU software
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
LAN
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
LAN