INSP
ADJ
CONTROL SYSTEM
Turn the magneto control lever 3 so
that its adjusting screw contacts the
full retarding stopper a.
Adjust the position of the cable joint
until its hole aligns with the set pin.
Install the clip and tighten the lock nut.
WARNING
The cable joint should be screwed in more
than 8 mm (0.31 in).
NOTE:
Put the "UP" mark upward.
3. Check:
Throttle operation
Unsmooth operation → Repair.
Shift cable adjustment
1. Check:
Shift operation
Incorrect → Adjust.
2. Adjust:
Shift cable joint position
Adjustment steps:
Set the shift handle 1 in neutral.
Align the center of the set pin 2 with
the mark a on the bracket.
Adjust the position of the cable joint
until its hole aligns with the set pin.
Install the clip 3 and tighten the lock
nut 4.
WARNING
The cable joint should be screwed in more
than 8 mm (0.31 in).
NOTE:
Put the "UP" mark upward (manual starter
model only).
3. Check:
Shift operation
Unsmooth operation → Repair.
3-4
E