POWR
RECOIL STARTER
SERVICE POINTS
Sheave drum removal
1. Turn:
Sheave drum 1
Turn the sheave drum clockwise until
the spiral spring is free.
NOTE:
Turn the sheave drum so that the cutaway
on the outer surface of the sheave drum
faces toward the starter handle.
Pass the starter rope through the cut.
2. Remove:
Sheave drum 1
WARNING
When removing the sheave drum, be sure
to turn the sheave drum upside down to
prevent the spiral spring from popping up
at you.
NOTE:
Insert a slotted-head screwdriver into the
hole in the sheave drum, and remove the
spiral spring from the sheave drum by
pushing the spring.
Spiral spring removal
1. Remove:
Spiral spring 1
WARNING
Be careful so that the spiral spring does not
pop out when removing it. Remove it by
allowing it out one turn of the winding
each time.
Starter stopping plunger inspection
1. Inspect:
Starter stopping plunger
Crack/Wear/Damage → Replace.
5-5
E