Power; Adjusting Volume; Changing Channels; Cancel - JVC 1299-TN-JII-JMT User Manual

10 Getting Started

POWER

• Press the P button on the remote control or the front panel of the TV. The On Timer will glow re d .
O W E R
• Make sure the TV/CAT V switch on the remote is set to TV. Move the switch to CAT V only if you plan to operate
a cable box. On the CATV setting the remote will only operate the cable box functions.
• To turn the power off, press the P
• The On Timer lamp will glow green when the On/Off Timer is set (page 23), even when the TV power is off.

ADJUSTING VOLUME

To control the volume level, use the V
Use the V - (
O L U M E
Press the M button to instantly turn the volume to zero. Press the M
UTING
previous volume level.

CHANGING CHANNELS

10 key direct access
1
To move directly to a specific channel, press that channel's numbers on the remote's 10 key pad. For single-digit
channel numbers, press "0" then the channel number. For channels above 100, press the 100+ button, then the
remaining two digits on the 10 key pad.
2 C -/+
HANNEL BUTTON
To scan through the channels, press either the C
T V / V C R 's front panel and release. You will move through the channels in numerical ord e r.
• After you operate the Auto Tuner Setup (page 13), all of the empty channels will be removed from scanning.
When you scan you will only receive clear, active channels.
H y p e rs c a n
With JVC's Hyperscan feature you can zip through the channels at a rate of five per second. To use Hyperscan,
p ress and hold either the C
rest will move by at five per second. To scan at normal speed, press and release the C
3
Regular Return
P ress and release the R
Then select another channel using the 10 key pad buttons. You can now flip back and forth between these two
channels by pressing R
4
R +
ETURN
With R + ou can program your TV to always re t u rn to a specific channel. Press and hold down the R
E T U R N Y
button for three seconds. The message, "RETURN C H A N N E L P R O G R A M M E D ! " will appear on-screen. Now
when you scan through the channels, pressing R
To cancel the R + channel, press and hold the R
E T U R N
C H A N N E L C A N C E L L E D ! " will appear on-scre e n .
• Pressing any number key or turning off the TV will also cancel the R
button again. The On Timer will go out.
O W E R
+/- b u t t o n s (
O L U M E
) button to lower the volume. Press the V
VOLUME 13
| | | | | | |
-------------------
+ or C
H A N N E L H A N N E L
+ button to re t u rn to the previous channel viewed. For example select a channel.
E T U R N
+.
E T U R N
) on the remote control or on the TV's front panel.
OLUME
+ ( ) or C
H A N N E L HANNEL
- buttons. After the first few channels scan at normal speed, the
+ will bring you back to your programmed channel.
E T U R N
+ button for three seconds. The message "RETURN
E T U R N
E T U R N
+ ( ) button to raise the volume.
button again to return to the
UTING
- ( ) button on the remote or
+ / - b u t t o n .
H A N N E L
+ c h a n n e l .
+
E T U R N