Vcr Plu+ - JVC 1299-TN-JII-JMT User Manual

VCR Plus+
Your TV/VCR combo comes equipped with VCR
Plus+ technology. This function lets you program
your VCR by simply entering the VCR Plus+ code
number associated with the program you wish to
record.
• Before VCR Plus+ can be used, the VCR Plus+
guide channels must be programmed. See VCR
Plus+ Guide Setup in "Initial Setup" page 15 if you
have not yet programmed these guide channels.
Timer Recording with VCR Plus+
Press VCR P
The VCR Plus+ code screen appears.
- - - - - - -
ENTER THE PLUSCODE
Enter the VCR Plus+ code (a three-to-eight digit
number) of the program you wish to record using
the 10 key pad on the remote control.
The following screen will appear:
1234
HOW OFTEN?
ONCE DAILY (M-F) WEEKLY
SELECT
RECORDING SPEED
IF ALL OK,
PUSH VCR PLUS
• If you enter the VCR Plus+ code incorrectly,
press C on the remote. The "Enter the
ANCEL
PlusCode" screen will reappear.
NOTES:
VCR Plus+ Codes can usually be found in most local newspaper television listings or in TV magazines. VCR Plus+ codes are
three-to-eight digit numbers usually printed after the program title or description in the TV listings.
VCR Plus+ and PlusCode are registered trademarks of Gemstar Development Corporation. The VCR Plus+ system is
manufactured under license from Gemstar Development Corporation.
+ on the remote control
LUS
SP EP
CANCEL BY
+
CANCEL
VCR Plus+
Press the D
AILY
how often a program should be recorded,
ONCE, DAILY, or WEEKLY
Press the SP/EP button to select SP or EP
recording speed. (See page 26 for more
on tape recording speeds)
Press the VCR P
The following screen will appear displaying a
summary of the information you just entered.
DATE
START
STOP
CHANNEL
RECORDING SPEED
IF ALL OK,
+
PUSH VCR PLUS
If the settings are correct, press the VCR P
button again to accept. The following message
will appear:
YOUR PROGRAM IS CONFIRMED
PUSH THE TIMER BUTTON
If you wish to make a correction, use the (
buttons to move to the item and the (
buttons to correct. Once corrected, press VCR
P + to accept the settings.
LUS
Press the T
IMER
control. The timer is now in standby
mode.
The REC TIMER lamp will glow green on the front
panel of the unit indicating that the timer has
been programmed. When the programmed star t
time arrives, the REC lamp will glow red and
recording will begin. When the programmed stop
time arrives, the lamp will go out and the
recording will automatically stop. If there are other
pre-set recordings, the REC TIMER lamp will glow
green.
/W button to select
EEKLY
+ button
LUS
MON - FRI
2:30 PM
3:00 PM
03
SP EP
CANCEL BY
CANCEL
LUS
)
button on the remote
27
+
)