Zone Setting - Toshiba Compliant Manager BMS-CM1280TLE Installation Manual

Compliant Manager
8

ZONE SETTING

Register groups in a zone or cancel them.
(1) Change the mode to the zone setting mode.
• Press the button,
(The displayed zone number flashes and the Compliant Manager enters the zone setting mode. Indicates
CODE No. "E1".)
(2) Select the zone to be set.
• Select the zone number to be set with the ZONE
selection.
(When the selection has been fixed, the selected zone number flashes.)
• When selection of zone has been fixed, the
(3) Change registration of groups in a zone.
Register groups in a zone.
1. Select the group number to be set with the GROUP
button skips the group number by +16 or by -16.
2. Press the button.
The marks of the registered group numbers light up. (
3. Pressing the button restores the state before the
4. To continue registration of groups, repeat this procedure from the beginning.
NOTE
No zone data has been stored at this time. If the ZONE
change is fixed, the set content for registration change is discarded.
(4) Fix the registration change.
Press the button. The set content for registration change is stored in the memory.
* After the memory write operation has been completed, the Compliant Manager exits the zone setting mode.
button, and ZONE
marks of the group numbers registered in the zone light up.
– 17 –
button simultaneously for at least 4 seconds.
or button, and then press the
or button. Pressing the SET TEMP.
→
)
button is pressed.
or button is pressed before the registration
Installation Manual
button to fix the
or
16-EN