Trouble Shooting - Pioneer 900107 Owner's Manual

Page 8

TROUBLE SHOOTING

Power switched on and compressor does not start up:
•
Check to make sure power cord is properly plugged in.
•
If water cooler was purchased and delivered in the winter, give it several
hours to warm up to room temperature before plugging in as both
temperature of water and temperature of water cooler itself can effect
thermostat setting. If temperature is below thermostat, compressor will not
start up. Thermostat was preset at factory and any adjustments will void
warranty.
Water Appliance is noisy during operation:
•
Ensure that water cooler is sitting on a level surface.
Water Cooler becomes too hot:
•
When in use, it is normal for back of water cooler to be hot. If you are
worried that temperature is too high, check to make sure that there is enough
room around the water cooler to allow ventilation. We recommend at least
2" clearance on all sides.
Cold Water is warm:
•
Check that cold water switch is in the on position.
•
Cold water consumption is greater than 33.8 fl oz per hour, thus exceeding
the capacity of compressor. Allow cooler to run for 1 hour without
dispensing cold water.
Water leaks from tap:
•
A calcium scale deposit may have formed in tap. Clean inside of water
cooler following cleaning instructions included in this manual.
Water leaks from cooler:
•
Water bottle may have small pinholes. Unplug unit, remove bottle and
check. Drain water through faucets, then replace with new bottle and open
faucets one at time until water flows. Then plug in water cooler and check
for leaks.
•
Check that drain plug on rear of water cooler is properly fastened.
•
Check drip tray and empty if full.
Owner's Manual Model #900107 Owner's Manual Model #900107
CARACTERISTICAS
•
El enfriador de agua puede usarse con botellones de tres o cinco
galones (11,3 o 18,9 litros)
•
Tecnología de refrigeración electrónica
•
Controles de temperatura prefijados en fábrica
•
El tanque de calentamiento esta hecho con acero inoxidable de calidad
sanitaria 304 para seguridad y larga vida útil
DESEMPACADO Y PREPARACION
DEL ENFRIADOR DE AGUA
PRECAUCION: Por su salud y seguridad
NO enchufe el enfriador de agua hasta que el agua salga a
través de ambos grifos, el de agua caliente y el de agua fría.
•
Remueva la unidad del cartón de empaque cuidando de no
voltearla o colocarla sobre el costado.
•
Remueva todos los materiales de amarre y abra la caja.
•
Remueva de la caja los materiales de empaque de espuma de
plástico.
•
Remueva la bolsa de plástico.
•
Limpie la unidad con un paño limpio.
•
La unidad debe colocarse sobre una superficie plana.
•
Coloque el enfriador de agua en una zona sombreada, no lo
ponga en luz solar directa y colóquelo a una distancia de por lo
menos 15 cm de la pared.
•
Verifique que todos lo interruptores están en posición de
apagado (OFF).
Manual del usuario, modelo n
Página 5
o
900107