Operation; Creating A Vision.net Touchscreen - Philips 95242A Installation & Operation Manual

Installation & User's Manual

OPERATION

1. Creating a Vision.net Touchscreen

Note: Follow these instructions ONLY if the touchscreen arrives without any setup information. Before beginning
the process of adding Vision.Net functionality to a touchscreen, be sure to inspect the screen to ensure that it is free of
all manufacturer defects.
To create a Vision.net Touchscreen:
Note: Before proceeding, contact Strand Lighting technical support via phone at 1.214.647.7880 or
1.800.4.STRAND or via e-mail at entertainment.service@philips.com for system files.
Step 1. Load system files obtained from Strand Lighting technical support onto a USB key.
Step 2. Power touchscreen.
Step 3. When booting is complete, insert programming USB key into screen.
Step 4. Open
Step 5. Copy
Step 6. Navigate to
Step 7. Paste
Step 8. Close all windows.
Step 9. Open the
Step 10. Select
Step 11. Double tap on
a. Select
b. Navigate to
c. Double tap on
Note: Old-style touchscreens used a file called
STARTUP FOR SHASTA
with
d. Verify that
e. Tap
f. Tap
Step 12. From the open
window.
a. Select
b. Set
Note: You must add the last 3 digits of the IP address if touchscreens are networked.
1 0
OPERATION
MYDEVICE/HARDDISK2
STARTUP FOR SHASTA
MYDEVICE/HARDDISK
STARTUP FOR SHASTA
START
menu.
SETTINGS/CONTROL PANEL
AUTOLAUNCH
BROWSE
.
MYDEVICE/HARDDISK
STARTUP FOR SHASTA
if using new Shasta firmware.
STARTUP FOR SHASTA
Save
.
OK X
. Note, if is pressed all changes will be lost.
CONTROL PANEL
CONTROL PANEL > SYSTEM > DEVICE NAME
DEVICE NAME
.
DEVICE NAME
from Table 3, "Touchscreen Device Names," on page 11.
.
.
.
into touchscreen.
.
. This will open a configuration window.
.
.
START FOR TOUCHSCREEN
now appears in the window.
SYSTEM
window select
Vision.net Touchscreens
. Delete this file and replace it
. This will open the device configuration
.