Table of Contents
Advertisement
Vision.net Touchscreens
Note: "-xxx" is the last three digits of the unit's IP address. * = Old hardware. Old Hardware designations are
included for service and support issues. These must not be used in new installations.
c. Tap X to close window.
Step 13. Close all open windows.
Step 14. Open the
Step 15. Select
settings window.
a. Tap and hold on any wireless connection for 3 seconds.
b. From menu select
c. Tap
Step 16. Open the START menu.
Step 17. Select
a. Check the box to
b. Uncheck the box for
c. Tap
Step 18. Close all windows.
MYDEVICE/HARDDISK
Step 19. Open
Step 20. Double tap on
Note: The USB key must be in place.
Step 21. Select
copy all necessary files from the USB key.
WARNING! Do not remove the USB key until the transfer is complete.
The Touchscreen is now ready for use.
Note: Depending on what
may display incorrectly. Please be sure that the file on the USB key is for the desired screen.
Touchscreen Type
Portable
7 (non-Aaeon) & 10 Inch
3.5 Inch
15 Inch (iEi only)
15 Inch (Aaeon only)
7 Inch (Aaeon only)
Table 3: Touchscreen Device Names
START
menu.
SETTINGS/NETWORK AND DIALUP CONNECTIONS
DISABLE
.
X
to close window.
SETTINGS/TASKBAR AND START MENU
AUTOHIDE
ALWAYS ON TOP
X
to close window.
STARTUP FOR SHASTA
UPDATE FIRMWARE AND LAUNCH APPLICATION
ActiveScreen.ntc2
Device Name
TS-P-xxx
TS-I-xxx
TS-D-xxx
TS-C-xxx
TS-B*-xxx
TS-A*-xxx
. This will open the Taskbar settings window.
.
.
.
. This will launch the Shasta environment.
UPDATE
file was present in the
Installation & User's Manual
. This will open the Network
. At this point, the touchscreen will
folder on the USB key the screen
Creating a Vision.net Touchscreen
11
Hide quick links:
Advertisement
Table of Contents
