Reversing Door - Kenmore Front Load Washer Installation Instructions Manual

Reversing Door Swing
1. Be sure you have adequate swing area before

reversing door.

2. You will need a screw driver with a #2 square and
straight bit.
3. Protect fl at work surface, such as top of washer or
fl oor near washer, with a soft cloth or towel.
4. Be sure washer is unplugged from power source!
Removing the door
1. Open washer door and remove the 4 hinge screws.
2. Supporting door with both hands, squarely slide door
and hinge outward approximately 3/8" (10 mm) so
hinge can be pulled from
shoulder bolts on front
panel.
Do not attempt
to remove the 2
shoulder bolts.
3. Gently place washer door face down on fl at, covered
work surface.
4. Remove 2 pan head screws and door strike from inner
door.
1 2
1
2
3
4
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source
before servicing could result in personal
injury or even death.
5. Locate the 15 indented head screws - 8 in the small,
circular recesses at top and bottom edge of the inner
door, 2 on the latch-side edge, and 5 on the hinge-side
edge. Remove and save these 15 screws.
1
2
15
13
14
6. Separate inner door assembly from outer door
assembly.
STRIKE
SUPPORT
BLOCK
IMPORTANT
DO NOT remove the hinge or strike support block.
12
Tools needed:
Screwdrivers with
#2 square &
straight bit
4
5
3
6
11
12
HINGE
7
8
9
10