Sony MZ-S1 Service Manual page 19

SOUND SKIP CHECK RESULT DISPLAY MODE
This set can display the count of errors that occurred during the
recording/playing for checking.
• Setting Method of Sound Skip Check Result Display
Mode
1. Set the test mode (see page 15).
2. Press the key or
N >
and the playing or recording sound skip result display mode
becomes active respectively where the LCD displays the fol-
lowing.
Set LCD display
000
P**R**
Total count of play
system errors (hex.)
3. When the N > key is pressed, total error count is displayed
on the LCD, and each time the
display item moves down by one as shown below. Also, if
the key is pressed, the display item moves up by one,
.
[T MARK/REC]
then if the
display in the record mode appears.
[T MARK/REC]
When the
error count is displayed on the LCD, and each time the
is pressed, the display item moves down by one as shown below.
Also, if the key is pressed, the display item moves up by
.
one, then if the key is pressed, the display in the play
N >
mode appears.
Playing sound skip
result display
000 P * * R**
000 E I B **
000 S t a t**
000 A d r s**
000 B E m p**
000 # # # ###
P**R** : Total play/record errors (hex.)
** : Counter of sound skip check each item (hex.)
###### : 6-digit address where sound was skipped last (hex.)
[T MARK/REC]
and
N >
Total count of record
system errors (hex.)
N > key is pressed, the
and keys are pressed, the
N >
and keys are pressed, total
N >
N >
Recording sound skip
result display
000 P* *R**
000 BO vr**
000 Bf ul**
000 Rt ry**
000 ## ####
• Cause of Sound Skip Error
Cause of error
EIB
Stat
Play
Adrs
BEmp
keys,
BOvr
Record
Bful
Rtry
4. To quit the sound skip check result display mode and to return
to the test mode (display check mode), press the
• Setting Method of Key Check Mode
1. Set the test mode (see page 15).
[T MARK/REC]
2. Press the
activates the key check mode. (At the last two digits, AD value of
remote commander key line is displayed in hexadecimal)
Remote commander LCD display
004
key
3. When each key on the set is pressed, its name is displayed on
the LCD. (The operated position is displayed for 4 seconds
after the slide switch is operated. If any other key is pressed
during this display, the LCD switches to its name display)
Example1: When the
Set LCD display
004
4. When all the keys on the set and on the remote commander are
considered as OK, the following displays are shown for 4 sec-
onds.
Example2: When the keys on the set are considered as OK:
Set LCD display
888
5. When all keys were checked or if the upper case is opened, the
key check mode quits and the test mode (display check mode)
comes back.
MZ-S1
Description of error
Sound error correction error
Decoder status error
Address access error
Buffer is empty
Buffer is full, and sounds were
dumped
Buffer capacity becomes less,
and forcible writing occurred
Retry times over
x
and keys on the remote commander
X
key on the set is pressed:
N >
FF
SET OK
key.
19