User Rights - Siemens SPCK420 User Manual

SPCK420/421/422 LCD-Keypad - User Manual
Appendix > User rights

User rights

Based on the operational features of the SPC system, described below, users have rights attributed to the user profiles.
The installation engineer will inform users of their user rights assigned to each user profile. Depending on how the
system has been programmed, users may have rights to all or some of these features.
User rights
Fullset
Limited
Standard
Manager
The FULLSET operation fully sets the alarm system and provides full protection to a building (opening of any alarm
zones activates the alarm).
On selecting FULLSET, the buzzer sounds and the keypad display counts down the exit time period. Exit the building
before this time period has expired.
When the exit time period has expired, the system is set and opening of entry/exit zones starts the entry timer. If the
system is not Unset before the entry timer expires, the alarm is activated.
Partset A
Standard
Manager
The PARTSET A option provides perimeter protection to a building while allowing free movement through the exit and
access areas.
Zones that have been classified as EXCLUDE A remain unprotected in this mode. By default, there is no exit time; the
system sets instantly on selection of this mode. An exit timer can be applied to this mode by enabling the Partset A
timed variable.
Partset B
Standard
Manager
The PARTSET B option applies protection to all zones except those that have been classified as EXCLUDE B.
By default there is no exit time; the system sets instantly on selection of this mode. An exit timer can be applied to this
mode by enabling the Partset B timed variable.
Forceset
Standard Manager
The FORCESET option is presented on the keypad display when an attempt is made to set the system while an alarm
zone is faulty or still open (the top line of the display shows the open zone).
Selecting this option sets the alarm and inhibits the zone for that set period.
Unset
Limited
Standard