Specifications - Toro Greensmaster
Flex 18 04018 Service Manual

Specifications

REEL CONSTRUCTION: 5–inch (12.7 cm) diameter,
11 carbon steel blades welded to 5 stamped steel spi-
ders. High strength low alloy steel blades are thru hard-
ened and impact resistant. An optional 8 blade cutting
reel is available.
FRAME CONSTRUCTION: Precision machined die
cast aluminum cross member with two bolt–on die–cast
aluminum side plates.
HEIGHT–OF–CUT: Cutting height is adjusted on the
front roller by two vertical screws and held by two lock
nuts. Standard bench height of cut range is 1/16 to 19/64
inch (1.6 to 7.5 mm) depending on type of bedknife
installed. Effective HOC may vary depending on turf
conditions, type of bedknife, rollers and attachments
installed.
CLIP:0.14 inch (3.56 mm) with 11 blade reel.
0.19 inch (4.83 mm) with optional 8 blade reel.
Cutting Unit
BEDKNIFE AND BEDBAR: Single edged high carbon
steel bedknife, hardened to RC 48-54. A cast iron bed-
bar is fastened to the cutting unit.
GRASS SHIELD: Non–adjustable shield with adjusta-
ble cut–off bar to improve grass discharge from reel in
dry conditions.
COUNTERBALANCE WEIGHT: A cast iron weight
mounted on right end of cutting unit balances the cutting
unit.
APPROXIMATE WEIGHT:
Flex 18 with11 Blade Reel
Flex 21 with 11 Blade Reel
Page 7 – 2
81 lb. (36.7 kg)
89 lb. (40.4 kg)
Greensmaster Flex 18/21