Kenwood KVC-1000 Instruction Manual page 31

On cars where there is no compartment in the centre for installing a car audio unit:
Use the spacer (Accessory 0) to affix the centre unit sleeve and the sleeve attached to the main unit in such a way
that they are correctly aligned both depthwise and horizontally.
On cars lacking a centre
compartment
Removing Unit
Removing the Hard Rubber Frame
1
Engage the catch pins on the removal tool and
remove the two locks on the lower level.
Lower the frame and pull it forward as shown in the
figure.
Accessory 4
Removing the Unit
1
Refer to the section "Removing the Hard Rubber
Frame" and then remove the hard rubber frame.
2
Remove the Hex-head screw (Accessory 9) with
integral washer (M4 8) on the back panel.
3
Insert the two removal tools deeply into the slots on
each side, as shown.
2 CAUTION
Be careful to avoid injury from the catch pins on the
removal tool.
4
Lower the removal tool toward the bottom, and pull
out the unit halfway whilst pressing towards the
inside.
Catch
Lock
Catch facing up
2
When the lower level is removed, remove the upper
two locations.
NOTE
The frame can be removed from the top side in the
same manner.
5
Pull the unit all the way out with your hands, being
careful not to drop it.
7
Accessory 0
31