Clearances And Dimensions - Electrolux 30” GAS FREESTANDING RANGES Service Update Manual

30" GAS RANGE INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
If the information in this manual is not followed
exactly, a fire or explosion may result causing property
damage, personal injury or death.
FOR YOUR SAFETY:
— Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
— Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
44 5/8"

Clearances and Dimensions

1. Location—Check location where the range will be
installed. Check for proper electrical and gas supply,
and the stability of the floor.
2. Dimensions that are shown must be used. Given
dimensions provide minimum clearance. Contact
surface must be solid and level.
(For Models with Sealed Top burners)
Provide Proper Fuel Type
Before Proceeding: Your range is preset to operate on
natural gas.
Propane settings without the proper LP/Propane conversion
kit provided with the range or obtained from your dealer.
Follow all instructions provided with this conversion kit.
Page 11
Refer to your serial plate for
applicable agency certification
Note: For appliances installed in the
State of Massachusetts see page 2.
30"
DO NOT attempt to convert this range to LP/
P/N 316439221