Replacement Of The Primary Hdd In Sistore Ax8/Ax16 500/200 V3.6 - Siemens SISTORE AX Installation Instructions Manual

6.4 Replacement of the primary HDD in
SISTORE AX8/AX16 500/200 V3.6
Siemens Building Technologies
Fire Safety & Security Products
These instructions describe the replacement of the primary HDD unit in the
housing of a Digital Video Recorder of type SISTORE AX16 500/200. When
installing a HDD unit in AX8 500/200 proceed in the same manner.
Installation and replacement of hard disk drives
1. First shutdown the device and
disconnect from the power supply.
2. Remove the eleven screws on both
sides and at the rear of SISTORE AX.
See picture.
3. Lift up the housing cover at the rear of
the SISTORE AX, and lift it off. The
location for the hard disk unit is then
visible – see arrow.
4. Remove the HDD frame by loosening
the four screws inside the device; then
disconnect all cables from the hard disk
unit within the frame.
Note:
Be very careful when disconnecting the
data cables - they are not provided with
strain relief!
5. Remove the defect HDD and fit the
replacement hard disk unit into the
frame and secure it using the four
screws.
25
03.2009