Epson Discproducer PP-100N Administrator's Manual page 75

Error Message
Disc pickup
error (ST1/2)
Disc release
error
Discs ejected
from ST2?
Drive tray
open/close error
Fan control
error
Ink cartridge
cover open
Ink problem
(C,LC,LM,M,Y,K)
Internal drive
error (DRV 1/2)
Internal printer
error
Remedy
The arm cannot pick up the disc in the stacker. If the
indicated stacker is an input stacker, fully separate and
reload the discs in the stacker.
The arm cannot release the disc.
Do not remove the disc by hand. This could damage the
arm. Turn off the power of the product, and then turn it on
again. During the initialization operation of the product, the
arm releases the disc. If the same error message still
appears, repair is required. Please contact Customer
Support.
Perform the procedure below.
1. Remove the published discs from Stacker 2.
2. Refill the discs if necessary.
3. Press the button.
Note: In Batch Mode, if Stacker 2 is removed during
publishing progress, it is always recognized as the input
stacker when loaded again.
-When the drive tray does not come out-
Turn off the power, and then turn it on again. If the drive trays
still does not come out, see "Drive tray does not come out"
on page 91 in this guide. If the same error message appears
again, repair is required. Please contact Customer Support.
-When the drive tray does not close-
Remove any remaining discs, turn off the power, and then
turn on the power again. If the same error message still
appears, repair is required. Please contact Customer
Support.
Turn off the power, and then turn it on again. If the same error
message still appears, repair is required. Please contact
Customer Support.
Close the ink cartridge cover.
This product is currently operating.
Close the ink cartridge cover.
An invalid ink cartridge is installed.
Replace the cartridge of the displayed color. (See
"Changing the Ink Cartridge" in the PP-100N User's Guide.)
Turn off the power, and then turn it on again. If the same error
message still appears, repair is required. Please contact
Customer Support.
Turn off the power, and then turn it on again. If the same error
message still appears, repair is required. Please contact
Customer Support.
Troubleshooting
Notification
Sound
75