Tape Dubbing Operation (Deck A \ Deck B); Tape Dubbing - Kenwood CT/KXF-W Instruction Manual

Ct/kxf-w series stereo cassette deck
Table of Contents

Advertisement

Tape dubbing operation (Deck A \ Deck B)

The dubbing refers to the copy of the recorded contents of a tape to another tape (tape in Deck A \ tape in Deck B).
Since this unit is not designed for recording with metal (TYPE
20
1
Preparation
2
3

Tape dubbing

1
Perform auto-bias adjustment. (The bias adjustment is applied to deck B.)
For normal-speed dubbing.
NORM.DUBB
CT-2050/KXF-W6010
NORMAL
DUBBING
CT-203/KXF-W4010
To pause dubbing
For normal-speed dubbing.
NORM.DUBB
CT-2050/KXF-W6010
NORMAL
DUBBING
CT-203/KXF-W4010
To stop dubbing
Press the stop (7) key of Deck B.
1. The recording balance and recording level cannot be adjusted for dubbing.
2. The DOLBY NR is not active during dubbing.
The tape recorded by dubbing features the same NR system as the original tape in Deck A.
Notes
Notes
3. Noise from TV may interfere with dubbed sound if high-speed dubbing is executed near a TV set. To prevent this, install the system farther
from the TV set.
4. If the original tape was recorded at a high level, the sound quality may be degraded, if high-speed dubbing is used. In such a case, use normal-
speed dubbing.
Load the tape to be played in deck A and
the tape to be recorded in deck B. 0
Set the tape transport directions of decks
A and B to the same direction ( by
pressing the play (2 or 3) key then
pressing the stop (7) key immediately
after it ).
Make "Playback (recording) preparation".
AUTO BIAS
For high-speed dubbing.
HIGH DUBB.
CT-2050/KXF-W6010
HIGH
DUBBING
CT-203/KXF-W4010
For high-speed dubbing.
HIGH DUBB.
CT-2050/KXF-W6010
HIGH
DUBBING
CT-203/KXF-W4010
2
7
3
) tapes, do not use metal tapes for recording.
CT-203/KXF-W4010 only
CT-2050/KXF-W6010 only
: Keys and control used in the operations described on this page.
After approximately
"AUTO BIAS"blinks.
40 seconds
÷ The optimum bias is set in about 40 seconds, after which the deck
enters the stop mode.
÷ Recording is possible even if the auto-bias adjustment operation is
omitted.
Normal dubbing:
Dubbing at the normal
speed.
"DUBBING NORMAL" lights up.
÷ Only deck B enters the record- pause mode after leaving a non-
recorded space of about 4 seconds in case of normal-speed dubbing,
or about 6 seconds in case of high-speed dubbing.
÷ To resume dubbing after pause, press the same DUBBING key as
above (NORMAL DUBBING or HIGH DUBBING) again.
÷ Both decks A and B enter the stop mode.
CT-2050/203/KXF-W6010/W4010 (En/M)
"AUTO BIAS" lightsup.
High-speed dubbing:
Dubbing at about twice the
normal speed.
"DUBBING HIGH" lights up.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ct-203Ct-2050Kxf-w4010Kxf-w6010

Table of Contents