How To Record (Deck B Only) - Kenwood KXF-W1030 Instruction Manual

How to record (deck B only)

Since this unit is not designed for use with metal tapes,
recording on metal tapes cannot be carried out.
14
Preparation
Insert a tape in deck B.
1
Set up the cassette deck.
1 Select the Dolby NR mode.
(dB) — —5 0 +3 +6 (dB)
2 Select the recording mode.
(CT-403/KXF-W3030 only)
(dB) — —5 0 +3 +6 (dB)
2
Select the source to be recorded.
3
Set the recording level.
1 Play a music source.
2 Enter the record-pause mode.
—
(dB) —5 0 +3 +6 (dB)
3 Adjust the recording level.
(dB) — —5 0 +3 +6 (dB)
4 Stop playing the source.
4
Start recording.
1 Play the music source from the
beginning.
2 Press the ÷REC/ARM key.
Press once.
(dB) — —5 0 +3 +6 (dB)
A
(dB) — —5 0 +3 +6 (dB)
1 ¡ 8 ¶
PAUSE REC/ARM
@ 7 #
DOLBY NR
REV.MODE
8 ¶
PAUSE REC/ARM
REC LEVEL
MIN MAX
¶
REC/ARM
The figure shows an example for the CT-403 or KXF-W3030
PUSH/OPEN
0
POWER
1 ¡
A
TAPE
AUTO REVERSE
@ 7 #
: Keys or controls to be used in this operation
÷
Press to record with the DOLBY NR.
1 Dolby NR on
2 Dolby NR off
÷ Each press switches the indication.
1 "[" :Double-side recording which stops tape after having
recorded both sides.
2 """ :Recording stops after having recorded both sides.
3 """ :One-way recording which stops tape after having re-
corded a single side.
÷ While pressing the PAUSEkey,
press the REC/ARM key.
÷ Adjust so that seg-
ments around the 0 dB
segment of the peak
level meter light up at
times.
÷ Recording will start.
÷ The deck enters the stop mode automatically when the tape has
been recorded till the end. (CT-401/KXF-W1030)
PUSH/OPEN
0
(dB) — —5 0 +3 +6 (dB)
1 ¡ 8 ¶
PAUSE REC/ARM
B
TAPE
AUTO REVERSE
@ 7 #
Dolby NR off
Dolby NR on
DOLBY NR DOLBY NR
Goes off
Lit
(dB) —5 0 +3 +6 (dB)