Repeated Playback; To Repeat Only The Programmed Tracks - Kenwood D-R350 Instruction Manual

Repeated playback

Preparation
÷ Load a disc in the CD player.
18
÷ Set the INPUT SELECTOR to "CD" on the
: Complete the procedure in "Basic Operations
GRC operation
for the Graphical Remote Control Unit (GRC)"

To repeat only the programmed tracks

RC operation
1
P.MODE
2
DISC SKIP
REPEAT
3
+10
1 2 3 4 5
6 7 8 9 0
4
P.MODE
5
6
REPEAT
Main unit operation
The current status is displayed when the key is pressed
once. When it is pressed while the status is displayed, the
repeat ON status can be set to OFF (or vice versa).
7
6
connected device such as AV CONTROL
CENTER or receiver.
90
GRC operation
Press so that the "PGM" indicator lights.
Mode
ENTER
PGM
ENTER
P.mode
ENTER
Select the disk.
Disc Skip
ENTER
3
Go to step within 8 seconds.
Select the desired track No.
1 2 3
4 5 6
7 8 9
0 +10
ENTER
4
Go to step within 8 seconds.
Set the entry.
P.mode
ENTER
2 4
Repeat steps – above.
Switch REPEAT ON.
Return
ENTER
Repeat
ENTER
Start playback.
PGM
ENTER
ENTER
: Keys and control used in the operations described on this page.
P G M 1 0 D
÷ All of the programmed tracks will be repeated.
÷ In case only one track is programmed, only that track will be repeated.
÷ Up to 32 tracks can be programmed. When "
more tracks can be programmed.
R E P E A
GRC operation
To display the current status, first select the Return icon and press
the ENTER key, and then select the Repeat icon and press the
ENTER key.
Pressing the ENTER key again while the status is displayed will set
the repeat ON status to OFF (or vice versa).
To cancel repeated playback
Press the REPEAT key twice. (REPEAT ON
D-R350 (En)
I S ? C
FULL
" is displayed, no
T ON
(
OFF)