Volume; Attenuator; Loudness; Audio Control - Kenwood eXcelon KDC-X991 Instruction Manual

Volume

Increasing Volume
Turn the [VOL] knob clockwise.
Decreasing Volume
Turn the [VOL] knob counterclockwise.

Attenuator

Turning the volume down quickly.
Press the [ATT] button.
Each time you press the button, the Attenuator
turns ON and OFF.
When the Attenuator is ON, the "ATT" indicator
blinks.

Loudness

Compensating for low and high tones during low
volume. (Only the low tone is compensated for
when the tuner is selected as a source.)
1
Enter Loudness mode
Using the Control knob, select "DSP" > "SND
CONT" > "LOUD".
For the operation method, refer to <Function
Control mode> (page 11).
2
Select the Loudness
Turn the Control knob.
Each time you push the knob, the Loudness turns
ON and OFF.
3
Exit Loudness mode
Press the Control knob.

Audio Control

1
Select the source to adjust
Press the [SRC] button.
Refer to <Selecting the Source> (page 8).
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Audio item
Turn the [VOL] knob.
Adjustment Item Display
Rear Volume "REAR VOLUME"
Subwoofer level "SUBWOOFER LEVEL" –15 — +15
Balance "BALANCE"
Fader "FADER"
Exit Audio Control mode (Volume control mode)
5
Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob, [0] and
[ATT] button.
Range
0 — 35
Left 15 — Right 15
Rear 15 — Front 15
9
|
English