Advertisement
Example
This setting allows you to skip the TV, HDMI or PC IN Input
("TV", "PC IN", "HDMI 1", "HDMI 2", "HDMI 3" and "HDMI
4") on the Input Selection
operation.
• If you connect external equipment to an HDMI IN terminal
which you have set to be skipped, a notification
message
appears on the display when a signal is received from
the connected
external equipment.
Press "Yes" to reset
the related skipping setting so that the input terminal
becomes available.
i
i!!i!i!i!il
ililiiii!!il
ii ii!iiiiili
You can make various settings to enhance 3D image
viewing.
(See l)aae 5-11.5-12.t
This function sets the terminal to output the computer audio.
The adjustment items vary depending on the input source.
Select the input source corresponding
to the terminal
connected
to the PC and then adjust the desired item.
To perform the operation,
refer to "Setup" > "Advanced"
>
"Audio Select".
(See Daae 8-2._
Allows you to select what controls the audio output.
Fixed: Sound via speaker is adjusted with VOL+/-
on the
remote control unit or on the TV.
Sound via the AUDIO OUT terminal is not adjustable and
outputs at a consistent
level.
Variable:
Sound via the AUDIO OUT terminal is adjusted
with VOL+/-
on the remote control unit or on the TV.
Sound via speaker is muted.
You can output digital audio to an AV amplifier or similar
device whose DIGITAL AUDI© INPUT terminal is connected
to the DIGITAL AUDIO OUT terminal on the TV. Please
select an audio output format compatible with the audio
format of the program you are watching
and the equipment
connected.
PCM: For connecting to equipment that does not support
Dolby Digital and DTS. The same audio (main, sub, or
main/sub)
as the audio of the program being viewed is
output.
2-channel
audio with a sampling rate of 48 kHz or less is
output as linear PCM audio.
Bitstream:
For connecting
to an audio system that
supports Dolby Digital and DTS. Audio is output through
both the main and sub channels.
• Analog channel audio and video input audio are output in
PCM mode even when "Bitstream"
is selected.
• PCM digital input signals are output in PCM mode even
when "Bitstream"
is selected.
ENG 4-20
Advertisement
