Help? Troubleshooting - Kenwood DDX7034BT Instruction Manual

Kenwood gps navigation system/monitor with dvd receiver instruction manual
Hide thumbs Also See for DDX7034BT:
Table of Contents

Advertisement

Help?
Troubleshooting
Some functions of this unit may be disabled by
some settings made on this unit.
• Cannot set up the subwoofer.
!
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
Subwoofer is not set to On.
(page 76)
The DSP Select is Bypass.
Control> (page 76)
The Dual zone function is enabled.
Control> (page 61)
The unit is set to STANDBY source.
• Cannot select the output destination of the
!
subsource in the Dual zone.
• Cannot adjust the volume of the rear
speakers.
The Dual zone function is disabled.
Control> (page 61)
Cannot play audio files.
!
"CD Read" of <Disc Setup> (page 80) is set to
"2".
Cannot Folder select.
!
The Random play function is enabled.
Cannot perform Repeat play.
!
The PBC function is enabled.
• Cannot set up the equalizer.
!
• Cannot set up the crossover network.
The Dual zone function is enabled.
Control> (page 61)
The DSP Select is Bypass.
Control> (page 76)
The equalizer is set to "iPod".
Control> (page 60)
The unit is set to STANDBY source.
<Speaker Setup>
<DSP Bypass
<Zone
<Zone
<Zone
<DSP Bypass
<Equalizer
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
The Touch Sensor Tone doesn't sound.
?
The preout jack is being used.
The Touch Sensor Tone can't be output from
the preout jack.
Tuner source
Radio reception is poor.
?
The car antenna is not extended.
Pull the antenna out all the way.
The antenna control wire is not connected.
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
Disc source
The specified disc does not play, but another
?
one plays instead.
The specified CD is quite dirty.
Clean the CD.
The disc is severely scratched.
Try another disc instead.
Audio file source
The sound skips when an Audio file is being
?
played.
The media is scratched or dirty.
Clean the media, referring to the CD
cleaning of the section on <Handling discs>
(page 6).
The recording condition is bad.
Record the media again or use another
media.
English
93

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dnx7000exDdx714Dnx7140

Table of Contents