Display; Switching The Display Modes - Kenwood G-EQ300 Instruction Manual

Display

Preparation
1 0

Switching the display modes

1
Press the ON/STANDBY key to turn the unit ON.
2
Select the desired display mode.
Graphic equalizer display mode
Shows how each frequency range is compensated.
The graphic equalizer display also appears for about 5 seconds, even
while the unit is in the spectrum analyzer display mode, when one of
the following operation is performed.
1. Turning the unit ON.
2. An operation key associated with an equalizer operation is pressed.
Spectrum analyzer display mode
Displays the frequency distribution of the source being played to allow
under standing at a glance.
The peak value of the varying level of each frequency range is held and
displayed for about 0.5 second.
DEMO(Demonstration) mode
After "DEMO" is displayed, the demonstration of the graphic equalizer
curves starts.
¶Ensure that the MAIN POWER key is set to
ON.
MAIN POWER
-ON –OFF
ON/STANDBY
DISPLAY
: Keys and control used in the operations described on this page.
Each press switches the display modes as follows.
1 Graphic equalizer display mode
2 Spectrum analyzer display mode
3 DEMO(Demonstration) mode
40 63 98 160 250 400
40 63 98 160 250 400
G-EQ300 (En/K)
625 1k 1.5k 2.5k 3.9k 6.3k 10k 16 k
Peak hold level
625 1k 1.5k 2.5k 3.9k 6.3k 10k 16 k