JVC MX-G50 Service Manual page 6

MX-G50/MX-G56
Removing the CD Tray fitting (1)
Prior to performing the following procedure, remove
the metal cover.
1. Press the POWER button. Press the OPEN/CLOSE
button to eject the CD tray.
2. After drawing the lower part of the tray fitting toward
the front, remove the five claws a. Then, while
moving the tray fitting upward, remove it.
3. Press the OPEN/CLOSE button to insert the tray.
Removing the CD Tray fitting (2)
- How to eject the CD tray without turning on power -
1. Turn the black loading pulley gear marked b from the
back of the CD changer unit as shown in Fig.7 and
draw the CD tray toward the front.
2. After drawing the lower part of the tray fitting toward
the front, remove the five claws a. Then, while
moving the tray fitting upward, remove it.
3. Push and insert the CD tray manually.
b
(Loading pulley gear)
1-6
(See Fig. 4 to 6)
(See Fig. 5 to 7)
(See Fig. 24)
This slot of the board.
Fig.7
CD tray
POWER button
Joint
CD tray fitting
Claw a
CD tray
OPEN/CLOSE button
Fig.4
Fig.5
Fig.6