Toshiba C1 Installation Manual page 11

4. The settings on the System tab screen (shown at
right) are configured by DCM automatically,
but may need to be changed. Modify the
following settings to the specified value.
Parameter
BLTAddress
BLTInterrupt
ISABusWidth
5. Click Apply when finished.
6. Repeat Substeps 3~5
boards.
7. From the DCM Main screen, select Service,
Startup Mode, then Automatic to enable the
Dialogic Services to start automatically when
the Windows NT system powers on.
8. From the DCM Main screen, click the Start icon on the toolbar
...or select Service, then Start Service. Click OK when the process is finished.
Notes
•
If the Dialogic Service does not start, double-click on the board name shown on the
configuration tree
...or from the Main menu, click Action then Configure Device. The board configuration tab
screens (i.e., System, Misc, Country) display. Verify the settings.
•
It can be helpful to run the Universal Dialogic Diagnostics Utility in the Dialogic System
Software program group to identify any problem(s).
9. Click File, then Exit. The DCM Main screen closes.
10.Go to Step 9: Connect Voice Board(s) to Telephone Lines
installation procedure.
Step 9: Connect Voice Board(s) to Telephone
Lines
A standard telephone does not function when directly attached to the board jack.
Note
1
To PBX or Voice
Central Office Channel 1 (RJ11C)
To PBX or Voice
Channel 2
Central Office
2
MIC
IN
OUT
5960
ProLine/2V
Stratagy ES Model C1 Installation Guide
Value
d0000
7
16-bit
above for any additional
Rear Bracket
(RJ11C)
1
2
J1
3
(RJ14C)
4
1
2
J2
3
4
(RJ14C)
Dialog/4
12/01
Stratagy ES Model C1 Installation Guide
Step 9: Connect Voice Board(s) to Telephone Lines
on page 7
Corresponding J1 and J2
Channel assignments
1 Ring
Channel 1
2 Tip
Chan. 1 Chan. 2
Channel 2
3 Ring
4 Tip
Channel 3
1 Ring
Channel 4
2 Tip
Chan. 3 Chan. 4
3 Ring
4 Tip
5977
to continue the system
Rear Bracket
on Board
To PBX or
RJ11C
Public
RJ11C
Telephone
Network
RJ11C
(Central
RJ11C
Office)
5978
D/41ESC
7