Toro Groundsmaster 4000-D Service Manual page 113

Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
NOTE: To ease reassembly, tag the hydraulic hoses to
show their correct position on the axle motor.
3. Disconnect hydraulic hoses from motor. Put caps or
plugs on ports to prevent contamination.
IMPORTANT: Support axle motor to prevent motor
from falling during removal.
4. Remove motor using Figure 60 as a guide.
Groundsmaster 4000--D
Installation
1. If removed, install pinion gear to axle motor.
2. Install o--ring onto motor. Position motor to rear axle
assembly making sure that arrows on the side of motor
case point upward. Align gear teeth and slide motor into
place.
3. Secure motor to axle with cap screws and flat wash-
ers. Torque screws from 59 to 73 ft--lb (80 to 99 N--m).
4. Remove plugs from ports. Attach hydraulic hoses to
axle motor.
5. Fill reservoir with hydraulic fluid as required (see Op-
erator's Manual).
6. After assembly is completed, verify that hydraulic
hoses and fittings do not contact anything.
Page 4 - - 79 Hydraulic System (Rev. B)