Connections; Audio Connections - Bosch VideoJet X10 Installation And Operation Manual

20 en | Installation
4.3

Connections

4.3.1 Camera
You can connect a video source to the VideoJet X10. Any cameras and other video sources
that produce a standard PAL or NTSC signal are suitable.
1.
2.
4.3.2

Audio Connections

The VideoJet X10 has two audio ports for audio line signals.
The audio signals are transmitted two-way and in sync with the video signals. As a result, you
can connect a speaker or door intercom system at the destination point, for example. The
following specifications should be complied with in all cases.
1 × Line In:
1 × Line Out:
The stereo plugs must be connected as follows:
Contact
Tip
Middle ring
Lower ring
1.
2.
4.3.3 Network
You can connect the VideoJet X10 to a 10/100 Base-T network using a standard UTP
category 5 cable with RJ45 plugs. The second Ethernet interface can be used to create a
redundant connection to the network.
NOTICE!
i
You cannot create a connection to a second network.
1.
2.
V3.0 | 2007.09
Connect the camera or another video source to the BNC Video In socket using a video
cable (75 Ohm, BNC plug).
If the video signal is not looped through, termination is performed by a software setting if
necessary (see Abschnitt 5.13 Video Input, Seite 43).
Impedance 9 kOhm typ., 5.5 V
Impedance 10 kOhm typ., 3.0 V
impedance 16 Ohm min., 1.7 V
Connect an audio source with line level to the Audio In socket of the VideoJet X10 with a
3.5 mm stereo plug.
Connect a unit with line-in connection to the Audio Out socket of the VideoJet X10 with a
3.5 mm stereo plug.
Connect the VideoJet X10 to the network via the ETH 1 socket.
Connect the VideoJet X10 to a redundant switch or hub on the same network via the
ETH 2 socket.
Installation and Operating Manual
max. input voltage
p-p
p-p
p-p
Line In function
Channel 1 (camera 1)
–
Ground
max. output voltage,
max. output voltage
Line Out function
Channel 1 (camera 1)
–
Ground
Bosch Security Systems
VideoJet X10