Panasonic WV-SW396A Installation Manual page 22

Step 5
Attach the front and rear sunshields (accessory) to the
camera.
q Put the fingers on the dents of the front and rear sun-
shields to detach the hooks. The sunshields will be
divided into two parts.
For loss prevention, one side of the front and rear
sunshields are linked together with a wire.
Detach the hooks.
w Locate the front and rear sunshields to the position
that covers the housing base.
Housing base
e Joint both sides of front and rear sunshields.
Joint the hook and dent on the linked side, and then
joint the other side.
Safety wire
22
Dents
Wire
START
LOCK
Front and rear sunshields
(accessory)
Front and rear sunshields
Important:
• Joint both sides of the front and rear sunshields
before fitting in the main sunshield.
• Do not trap the safety wire inside.
• The safety wire is designed to support only the weight
of the camera when the camera falls.
Do not put an excessive weight that the safety wire
cannot support.
Step 6
Fit the front and rear sunshields in the main sunshield.
Align "" of the rear sunshield to " START" of the main
sunshield. Then, turn the front and rear sunshields toward
" LOCK" until a click is heard.
Step 7
Fix the front and rear sunshields on the camera using the
front/rear sunshield fixing screw (accessory).
(Recommended tightening torque: 0.72 N·m {0.53 lbf·ft})
Important:
• When the power of the camera is turned on, the cam-
era will start panning and the position will automati-
cally be initialized.
Main sunshield
Note:
• When removing the front and rear sunshields, perform
steps 5 - 7 in the reverse order.
Front and rear sunshields
Main sunshield
Align "