Panasonic DMP-MST60 Operating Instructions Manual page 30

You have forgotten your ratings password.
You want to cancel the ratings level.
The ratings level returns to the factory preset.
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
– INFO LED and POWER LED start to flash,
and "00RET" is displayed on the screen.
3 Press [1] (right) repeatedly on the remote
control until "03 VL" is displayed on the
screen.
4 Press [OK].
This unit does not recognize the USB
connection correctly.
Disconnect and reconnect the USB cable. If it
still does not recognize the connection, turn
this unit off and on again.
USB devices may not be recognized by this
unit when connected using the following:
– a USB hub
– a USB extension cable
If you connect USB HDD to this unit, use the
USB cable that is supplied with the HDD.
The unit switches to standby mode.
This unit will automatically turn to standby
mode after 30 minutes if it is inactive.
Reference
Picture
The images from this unit do not appear on
the TV.
Picture is distorted.
An incorrect resolution is selected in "HDMI
Video Format". Reset the setting as follows:
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
– INFO LED and POWER LED start to flash.
3 Press and hold [8] and the blue button on the
remote control at the same time for more than
5 seconds.
Set the item again. (
– When Dolby Digital Plus audio is not output
properly, select "Yes" in "Default Settings"
and make proper settings. (
The unit and TV are using different video
systems.
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
– INFO LED and POWER LED start to flash,
and "00RET" is displayed on the screen.
3 Press [1] (right) repeatedly on the remote
control until "05P/N" is displayed on the
screen.
4 Press and hold [OK] for more than 5 seconds.
The system switches from PAL to NTSC or
vice versa.
Video is not output in high-definition.
Confirm that "HDMI Video Format" in the
Setup menu is set properly. (
3D image is not output.
Is there a non-3D compatible amplifier/receiver
connected between this unit and a TV? (
Are the settings on this unit and the TV
correct? (
Is the amplifier/receiver that is connected
between this unit and TV on?
A black band is displayed around the edge of
the screen.
The aspect ratio of the screen is abnormal.
Confirm the "TV Aspect" is set properly. (
Adjust the aspect setting on the TV.
- 30 -
24)
27)
24)
20)
8)
27)