Advertisement
[12]ADJUSTMENTS
1.Simulations
A. Entering the simulation mode
Simulation is hereinafter described as SIM.
Perform the following procedure to enter the SIM mode.
"#" key
Interrupt key
"C" key
Start key
Sub code
Start key
B. Canceling the SIM mode
When the clear all key is pressed, the SIM mode is cancelled.
When the interruption key is pressed, the process is interrupted and the
screen returns to the sub code entering display.
*
After canceling the SIM mode, be sure to turn OFF/ON the power
and check the operation.
Note:If the machine is terminated by a jam error or paper empty during
copying in the adjustment by the SIM, recopying is required.
Interrupt key
Main code
MX-M232D (ADJUSTMENT) 12 - 1
2.Copier adjustment
A.Mechanism section
Note:If a jam error or paper empty occurs during copying in the
adjustment by the simulation, the image data are not saved, and
therefore recopying is required.
(1) Image position adjustment
a. OC image lead edge position adjustment (SIM 50-1)
Note:In advance to this adjustment, the sub scanning magnification
ratio adjustment must be performed.
1) Set a scale on the OC table as shown below.
2) Make a copy.
3) Check the copy output. If necessary, perform the following
adjustment procedures.
4) Execute SIM 50-01.
Select a desired mode with the arrow keys, enter the adjustment
value with 10-key, and press [OK] key.
When [START] key is pressed, a sheet is printed.
When [RETURN] key is pressed, the process returns to the mode
selection window.
(Mode selection window 1)
Sim50-1 LEAD EDGE
1:TRAY1
50
2:TRAY2
50
3:MFT
50
1/2
[
1- 99]
50
(Copy start window)
Ready to copy.
S
100%
A4
<Adjustment specification>
Adjustment
SIM
Display
mode
text array
OC image lead
SIM
RRC-A
edge position
50-1
Main cassette
TRAY1
print start
position
2nd cassette
TRAY2
print start
position
Multi bypass
MFT
tray print start
position
Lead edge void
DEN-A
(Mode selection window 2)
Sim50-1 LEAD EDGE
4:DEN-A
50
5:RRC-A
1
6:DEN-B
50
2/2
[
1- 99]
50
(Copy execution window)
Copies in progress.
S
100%
A4
Set
Spec
Set
value
value
range
R/0.1
Lead edge
1 - 99
void:
1 - 4mm
H/0.1
Image loss:
3mm or
less
B/0.05
Advertisement
