PROGRAMMING THE REMOTE CONTROL
l
This Remote Control is preprogrammed to operate TOSHIBA VCR's.
l
To use VCR's other than Toshiba models (or Cable converter), perform the following procedures before operating.
CH A
For future reference, write the
code you used.
VCR CODE:
CABLE CODE:
TO CONTROL OTHER BRANDS OF VCR'S AND CABLE
CONVERTERS
Refer to the " VCR code table" (or "Cable TVconvetier code table") on
pages 16 and 17 to find the code number that corresponds to the
brand name of your VCR (or your converter).
RECALL
If more than one number is listed, try each one separately untit you
find the one that works.
Hold d own RECALL while pressing the Number buttons for the three
digit code number for your brand of VCR (or converter).
The transmit indicator tights up for l second when the programming
is completed.
When an operation error has occurred, the indicator blinks.
Press RECALL again to reset.
POWER to test the code number.
1 to 4 with another code number.
Notes:
l
You have to reprogram the Remote Control when you change its
batteries.
codes. These VCR's have a switch labeled "VCRWCR2".
If your VCR has this kind of switch, and does not respond to all the code
numbers for your VCR brand name, set the switch to another position
TV
2
i=
E