Panasonic JU-475-4 Service Manual page 21

I
Pig tail leading
(1) Pass the pig tail through the pig tail clamp.
(See Fig. 12-9-1.)
(2) locate the side 0 to the outer side and side 1 to
the inner side, provide a clearance of 1 mm
between them, and place them parallel to each
other.
(Avoid twisting or closing.)
(3) Fig. 12-9-2
[When the carriage is on the outer-most track]
(a) When the head carriage is on the outer-
most track, lead the side 0 and side 1 along
line A on the pig tail clamp.
(b) Ensure that the pig tail does not come in
contact with the inner wall of the base.
(Contacting of the pig tail is allowable if
the side 0 and side 1 are not overlapped
each other vertically.)
(4) Fig. 12-9-2
[When the carriage is on the inner-most track]
(a) When the head carriage is on the inner-
most track, lead the side 0 and side 1 along
line B on the pig tail clamp.
(5) Provide a clearance of about 1mm between the
side 0 and side 1.
(6) Ensure that there is not excessive load or
protrusion at the outlet for the pig tail in the
head carriage.
(7) Fasten the pig tail clamp with screw.
(8) Do not pull the pig tail by a force more than
500g after it has been clamped.
(9) Pull the pig tail lightly to ensure that it does
not move.
..19-
Pig Tail Clamp
Fig. 12-9-1 Mounting of the Pig Tail Clamp