Media Lifter Removal And Instahation; Media Sensor Assembly Removal And Installation - Panasonic JU-475-4 Service Manual

12.13 Media Lifter Removal and Installation
(1) Remove the clamp assembly as described in
section 12.5.
(2) Remove the lifter shaft clamping retaining ring
- draw out the lifter shaft.
(3) Remove the media lifter.
(4) Reverse the above procedure to reinstall.
Cartridge Guide
Lifter Shaft
~
Fig.12-13 Media Lifter Removal
- 22-
12.14 Media Sensor Assembly Removal and
Installation
(1) Remove the PCB as described in section 12.1.
(2) Remove the cartridge guide assembly as
descri bed in section 12.7.
(3) Draw out the pins of the media sensor assembly
from the following locations on the J3
connector: NoB, 10, 12.
At that time, draw out the pins with lifting the
stopper on the connector.
(4) Remove the media sensor assembly mounting
screw and take out the media sensor assembly.
(5) Reverse the above procedure to reinstall.
Fig.12-14 Media Sensor Assembly Removal