Miele CVA 6800 Operating And Installation Instructions page 79

Cleaning the milk pipework of any blockages
To reassemble the lid:
^ First insert the seal in the lid. If you
cannot insert it properly, try
moistening the seal with a little water.
^ Then insert the milk tube into the
seal.
Make sure that the slanted end of
the milk tube is facing downwards.
Otherwise the seal will get
damaged.
Step 2: Cleaning the air
suction tube and the elbow
connector in the door
Do not use a pin or other sharp
object as it will damage
components.
^ Open the service flap on the back of
the appliance door.
^ First pull the air suction tube a out of
the opening c. Then pull off the
elbow connector b.
^ Pull both tubes out of the elbow
connector.
^ Clean the air suction tube a using
the cleaning brush supplied. You can
also loosen blockages by blowing air
through the tube.
^ Clean the opening in the door for the
air suction tube c.
^ Clean the elbow connector b under
running water. If necessary, you can
replace it with the spare part
supplied with the machine.
^ Insert the brush in the milk tube d.
Move the brush back and forth as far
as possible until all milk residues
have been removed.
79