Yamaha 2012 TMAX XP500A Service Manual page 109

1. Rear brake hose
2. Fuel tank fitting bracket
3. Footboard
4. Rear frame
5. Left rear cowling
6. Rear brake hose holder (left)
7. Swingarm
8. Drive pulley cover
9. Passenger footrest
10.Rear brake lock cable holder bracket
11.Crankcase
12.Frame
13.Sidestand switch lead
14.Stay
15.Brake hose holder
16.Side cover (left)
17.Seat lock cable
18.Rear brake lock cable
19.Rear brake lock cable holder (crankcase)
20.Rear brake lock adjusting nut
21.Rear brake hose bracket
22.Rear brake hose holder (right)
23.Rear wheel sensor lead
24.Rear brake lock caliper
25.Rear brake lock cable holder (swingarm)
26.Rear brake caliper
27.Rear wheel sensor holder
28.Rear wheel sensor
A. Install the brake hose holder, aligning the
stopper of the brake hose holder with the
hole of the passenger footrest. To prevent
kinks, install the rear brake hose holder
(left) first and then brake hose holder.
B. Face the opening of the brake hose holder
upward.
C. Route the brake hose along the concave
face of the left rear cowling.
D. Install the cap, pushing it against the nut
and washer.
E. Route the rear brake lock cable under the
brake hose.
F. Face the opening of the cable holder to the
inside of the vehicle.
G. Install the rear brake lock cable holder
(crankcase), inserting the projection of the
cable guide into the hole of the rear brake
lock cable holder bracket.
H. Install the rear brake hose holder (left),
inserting the projection of the rear brake
hose holder (left) into the hole of the rear
brake hose bracket.
I. Install the rear brake hose holder (right),
inserting the projection of the rear brake
hose holder (right) into the hole of the rear
brake hose bracket.
J. Install the holder, pushing it against the
rear wheel sensor protector end.
K. 60–70 mm (2.36–2.76 in)
L. Tighten the union bolt, pushing the brake
pipe against the projection of the brake cal-
iper.
2-54
CABLE ROUTING